ADVANTAGES OF FIBERGLASS CONDUIT & STRUT

  • Easy to cut.
  • Light to work with.
  • No chlorine, halogen or other toxic materials
  • Temp range -40F to +230F
  • High temperature rating results in no cable fusion
  • Impervious to a wide spectrum of chemicals and fuels
  • Non-Conductive
  • Non-Corrosive
  • Complete line of fittings
  • Lower job cost because smooth inner wall allows longer cable pulls without burn through
  • Fewer manholes & vaults

 

 

BELOW GROUND FIBERGLASS CONDUIT

  • Save time & cost on assembly
  • Push fit Tri-Seal (1 piece urethane gasket )
  • No adhesive or threading
  • Tri-Seal joint is watertight up to 50 Psi
  • Superior impact & crush resistance
  • Rot & rodent proof
  • Highest strength to weight ratio of any conduit
  • Suitable for Direct Burial (DB) and/or Encased Burial (EB)
  • Available in 3/4 inch (19 mm) through 8 inch (203 mm) diameters

 

 

ABOVE GROUND FIBERGLASS CONDUIT

  • Save time & cost on assembly
  • Tri-Seal joint is watertight up to 50 Psi
  • Fire resistant and non-toxic
  • Thermal expansion rate is similar to RMC
  • More economical installation than PVC coated steel or RMC
  • Suitable for indoor use (non-hazardous locations)
  • Field bendable with hot box
  • Special colors available upon request
  • Quick push fit Tri-Seal (1 piece urethane gasket )
  • No adhesive or threading

 

 

LOW SMOKE/ HIGH TEMP FIBERGLASS CONDUIT

  • For tunnels, subways & confined areas (vent shaft, steam tunnels)
  • Emits no toxins or halogen (SMP 800C)
  • Thermal expansion rate is lower than RMC
  • Outstanding fire resistance (ASTM E84)
  • A more economical installation
  • Suitable for use indoors
  • No threading or masking of joints required
  • Bell and Spigot joint for fast, easy adhesive assembly
  • Class 1 fire rated (ASTM E84), NFPA 130 compliant, NFPA 502 compliant, FT4 rated (CSA)

 

 

UNDER WATER FIBERGLASS CONDUIT

  • Flexible & easy installationLowest installation cost
  • Can be installed year round
  • Excellent impact and compressive resistance
  • Complete line of conduit from 2 inch-6 inch ID
  • Capacity to design to specific requirements up to 30 inch casing with inner ducting system
  • All joints are spliced in continuous length on shore and pulled at once as a complete assembly
  • Best Market Award 2002 – JEC Paris, France